• SARBJIT SINGH

      Articles written in Sadhana

    • Partial dentures by centrifugal casting assisted by additive manufacturing

      GURPARTAP SINGH RUPINDER SINGH SARBJIT SINGH

      More Details Abstract Fulltext PDF

      This research work focuses on preparation of partial dentures (as functional prototypes) by additive manufacturing (AM)-assisted centrifugal casting (CC). The master pattern for partial dentures was prepared on fused deposition modelling (FDM) set-up (established by AM technique at low cost). The final dentures asfunctional prototypes were prepared with a nickel–chromium (Ni–Cr)-based alloy by varying different proportions of Ni% (N) by weight %. The other input parameters were powder to water P/W ratio (W) and pH value (H) of water used for mixing the investment. The samples prepared were ascertained for dimensional deviation (Δd), surface finish (Ra) and micro-hardness (HV) as output parameters. Finally, multifactor optimization has been applied on output parameters of functional prototypes prepared. This study highlights that partial denture prepared with W-100/15, H-7 and N-61% gives overall better results from mechanical properties and dimensional accuracy viewpoint. The results are also supported by photo-micrographic analysis.

  • Sadhana | News

    • Editorial Note on Continuous Article Publication

      Posted on July 25, 2019

      Click here for Editorial Note on CAP Mode

© 2017-2019 Indian Academy of Sciences, Bengaluru.