The Cadmium–Zinc–Telluride (CZT) Imager on board AstroSat is a hard X-ray imaging spectrometer operating in the energy range of 20–100 keV. It also acts as an open hard X-ray monitor above 100 keV capable of detecting transient events like the Gamma-ray Bursts (GRBs). Additionally, the instrument has thesensitivity to measure hard X-ray polarization in the energy range of 100–400 keV for bright on-axis sources like Crab and Cygnus X-1 and bright GRBs. As hard X-ray instruments like CZTI are sensitive to cosmic rays in addition to X-rays, it is required to identify and remove particle induced or other noise events and select events for scientific analysis of the data. The present CZTI data analysis pipeline includes algorithms for such event selection, but they have certain limitations. They were primarily designed for the analysis of data from persistent X-ray sources where the source flux is much less than the background and thus are not best suited for sources like GRBs. Here, we re-examine the characteristics of noise events in CZTI and present a generalized event selectionmethod that caters to the analysis of data for all types of sources. The efficacy of the new method is reviewed by examining the Poissonian behavior of the selected events and the signal to noise ratio for GRBs.

The Cadmium Zinc Telluride (CZT) Imager onboard AstroSat consists of pixelated CZT detectors, which are sensitive to hard X-rays above 20 keV. The individual pixels are triggered by ionising events occurring in them, and the detectors operate in a self-triggered mode, recording each event separatelywith information about its time of incidence, detector co-ordinates, and channel that scales with the amount of ionisation. The detectors are sensitive not only to photons from astrophysical sources of interest, but also prone to a number of other events like background X-rays, cosmic rays, and noise in detectors or theelectronics. In this work, a detailed analysis of the effect of cosmic rays on the detectors is made and it is found that cosmic rays can trigger multiple events which are closely packed in time (called ‘bunches’). Higher energy cosmic rays, however, can also generate delayed emissions, a signature previously seen in the PICsIT detector on-board INTEGRAL. An algorithm to automatically detect them based on their spatial clustering properties is presented. Residual noise events are examined using examples of Gamma Ray Bursts as target sources.