-
- Home
- Journals
- Bulletin of Materials Science
-
Yang Jian Feng
Articles written in Bulletin of Materials Science
-
-
Volume 34 Issue 7 December 2011 pp 1653-1661
Bai Yu Yang Jian Feng Lee Soo Wohn Chen Huang Yu Fang Li Zhang Jia
In this paper, effects of variables concerning slurry properties and drying conditions on the particle size and morphology of feedstock were discussed. The results indicated that, the increase of powder loading increased 𝐷50 and volume content but reduced recovery rate slightly. Other variables, such as inlet temperature, showed a maximum on the desired property. The particle size of resulting feedstock increased with the rise of feeding rate of slurry, however, decreased with the increase of atomization pressure based on the premise that atomization pressure was enough to force slurry to form the liquid membrane. For preparation of spherical feedstock, optimized variables were as follows: 60 wt.% powder in slurry, 2 wt.% PVA in slurry, inlet temperature of 60°C, atomization pressure of 13 × 103 KPa and feeding rate of 12 ml min-1. The volume content of feedstocks with 10–45 𝜇m was above 65% and for 𝐷50 it was 15.42 𝜇m. In addition, according to the heat and mass transfer equation, the drying mechanism was established, which was well in agreement with the experimental results.
-
-
Bulletin of Materials Science
Volume 46, 2023
All articles
Continuous Article Publishing mode
-
Bulletin of Materials Science | News
-
Dr Shanti Swarup Bhatnagar for Science and Technology
Posted on October 12, 2020Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020 -
Editorial Note on Continuous Article Publication
Posted on July 25, 2019Click here for Editorial Note on CAP Mode
-