Uma Maheswar Rao
Articles written in Bulletin of Materials Science
Volume 24 Issue 6 December 2001 pp 587-593 Surface Studies
In the present work, tracking phenomena has been studied with the ethylene propylene diene monomer (EPDM) material under the a.c. and d.c. voltages, with ammonium chloride/acid rain solution as the contaminant. It is noticed that the tracking time depends on the conductivity and flow rate of the contaminant. The physico-chemical analyses viz. wide angle X-ray diffraction (WAXD), thermo-gravimetric differential thermal analysis (TG-DTA) and the differential scanning calorimetry (DSC) studies, were carried out and it was concluded that the tracking process is a surface degradation process. The tracking time is different for a.c. and d.c. voltages.
Volume 25 Issue 6 November 2002 pp 473-475
In the present work, tracking phenomena has been studied with silicone rubber material under the a.c. and d.c. voltages following IEC-587 standards. The surface condition of the tracked zone was analysed using wide angle X-ray diffraction (WAXD) and thermogravimetric differential thermal analysis (TG–DTA) studies. The tracking time was different for a.c. and d.c. voltages.
Volume 45, 2022
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode