S C Patil
Articles written in Bulletin of Materials Science
Volume 14 Issue 5 October 1991 pp 1249-1255
Non-contact processing technique involving the use of CW and pulsed CO2 laser irradiation has been used for reducing the core loss of cold-rolled grain-oriented silicon steel. Laser scribing perpendicular to the rolling direction resulted in a refinement of domain wall spacing which subsequently reduced the loss of silicon steel. It was found that laser irradiation was more effective in a specimen with higher magnetic induction (Hi-B) and the loss was reduced by more than 10% under optimum conditions of the laser irradiation and the scribing speed. Since laser processing is a non-contact technique, it can be easily applied to the production line of the silicon steel.
Volume 17 Issue 6 November 1994 pp 829-839
Diamond like carbon films and C-N films were prepared using ion beam assisted deposition technique (IBAD). Tribological properties were studied by subjecting DLC coated films to the accelerated wear tests. These tests indicated a significant improvement in the mechanical surface properties of glass by DLC coating. Better wear features were obtained for thinner DLC coating as compared to the thicker ones. We also studied the optical properties and obtained a band gap of 1·4 eV for these films. An attempt was made to prepare C3N4 films by using IBAD. We observed variation in the nitrogen incorporation in the film with the substrate temperature.
Volume 45, 2022
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode