S Gouse Peera
Articles written in Bulletin of Materials Science
Volume 37 Issue 4 June 2014 pp 877-881
Hydroxyl ion (OH–) conducting anion exchange membranes based on modified poly (phenylene oxide) are fabricated for their application in alkaline polymer electrolyte fuel cells (APEFCs). In the present study, chloromethylation of poly(phenylene oxide) (PPO) is performed by aryl substitution rather than benzyl substitution and homogeneously quaternized to form an anion exchange membrane (AEM). 1H NMR and FT–IR studies reveal successful incorporation of the above groups in the polymer backbone. The membrane is characterized for its ion exchange capacity and water uptake. The membrane formed by these processes show good ionic conductivity and when used in fuel cell exhibited an enhanced performance in comparison with the state-of-the-art commercial AHA membrane. A peak power density of 111 mW/cm2 at a load current density of 250 mA/cm2 is obtained for PPO based membrane in APEFCs at 30 °C.
Volume 38 Issue 2 April 2015 pp 451-459
Synthesis of mesoporous carbon (MC) with well-defined morphologies and, wide range of surface area and pore size, is reported by organic–organic interaction between thermally decomposable surfactants (structure-directing agents) and the cost-effective carbon precursors, such as phloroglucinol and formaldehyde. Selected surfactants based on tri-block co-polymer, non-ionic and ionic, are used for synthesis of MCs with wide variation in their physical properties. The present method could be applied to large-scale production of porous carbon with desired surface area and pore morphology and would practically be relevant to many emerging technologies including electrochemical power sources such as super-capacitors and fuel cells. In the present study, we have successfully used MCs as gas-diffusion layers in fuel cell electrodes and established proper balance between air permeability and water management. The porous carbon contributes significantly to reduce mass transfer existing at high current density region resulting in improved performance of the polymer electrolyte fuel cells.
Volume 45, 2022
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode