S A Gerasimov
Articles written in Bulletin of Materials Science
Volume 30 Issue 4 August 2007 pp 415-419 Alloys and Steels
Joining of composite, Al2O3–TiC, with heat-resistant 9Cr1MoV steel, was carried out by diffusion brazing technology, using a combination of Ti, Cu and Ti as multi-interlayer. The interfacial strength was measured by shear testing and the result was explained by the fracture morphology. Microstructural characterization of the Al2O3–TiC/9Cr1MoV joint was investigated by X-ray diffraction (XRD) and scanning electron microscope (SEM) with energy-dispersion spectroscopy (EDS). The results indicate that a Al2O3–TiC/9Cr1MoV joint with a shear strength of 122 MPa can be obtained by controlling heating temperature at 1130°C for 60 min with a pressure of 12 MPa. Multi-interlayer Ti/Cu/Ti was fused fully and diffusion occurred to produce interfacial layer between Al2O3–TiC and 9Cr1MoV steel. The total thickness of the interfacial layer is about 100 𝜇m and Ti3AlC2, TiC, Cu and Fe2Ti are found to occur in the interface layer.
Volume 43, 2020
Continuous Article Publishing mode
Click here for Editorial Note on CAP Mode