• R Gnanamoorthy

      Articles written in Bulletin of Materials Science

    • Fretting fatigue in AISI 1015 steel

      R Gnanamoorthy R Rosi Reddy

      More Details Abstract Fulltext PDF

      A small osillatory movement between two contacting surfaces is termed as fretting and on many occasions it acts as the crack initiation site leading to catastrophic failure of the overall structure. The occurrence of fretting is observed in many engineering structures such as shaft flanges, gas turbines, steel ropes etc. An experimental facility, which can simulate the fretting fatigue in many engineering applications, is the primary requirement of the research program. A laboratory fretting fatigue test facility capable of varying many influencing parameters of fretting fatigue such as slip amplitutde, frequency, contact pressure, etc is designed and developed. Preliminary investigations on plain and fretting fatigue behaviour of AISI 1015 structural steel are reported in this paper. A strength reduction factor of about 1.30 was obtained due to fretting for the test material under the present experimental conditions. Influence of contact load on fretting was also studied. Increasing fretting contact load decreased the fatigue life in the range investigated. Failure analysis showed typical stage I oblique crack growth followed by stage II straight crack perpedicular to the fretting zone.

  • Bulletin of Materials Science | News

    • Dr Shanti Swarup Bhatnagar for Science and Technology

      Posted on October 12, 2020

      Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
      Chemical Sciences 2020

      Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
      Physical Sciences 2020

    • Editorial Note on Continuous Article Publication

      Posted on July 25, 2019

      Click here for Editorial Note on CAP Mode

© 2017-2019 Indian Academy of Sciences, Bengaluru.