O P Agnihotri
Articles written in Bulletin of Materials Science
Volume 8 Issue 3 June 1986 pp 279-284
Cd1−xZnxS/CuInSe2 solar cells having efficiencies in the range of 2·3% were fabricated by spray pyrolysis. The best cell had the following parameters:
Volume 8 Issue 3 June 1986 pp 315-318
Highly transparent and highly conducting films of SnO2:F were prepared by chemical vapour deposition technique. The films prepared at 350°C substrate temperature and 2·5 lit. min−1 flow rate of oxygen showed maximum figure of merit. The optimum doping concentration of fluorine was 1·02 wt%. The Hall experiment showed that the films prepared at optimum conditions had high carrier concentration and high mobility.
Volume 10 Issue 4 July 1988 pp 333-340
CdSe films on titanium have been prepared by spray pyrolysis and characterized by X-ray diffraction and X-ray photon spectroscopy. Photoelectrochemical solar cells with 4·84% conversion efficiency have been fabricated using these electrodes. Spectral response studies indicate absorption at sub-band gap energies. The band gap of CdSe as determined from photo-current studies was 1·66 eV. The flat band potential measured gives a value of −1·54 V with reference to SCE for electrodes prepared using cadmium chloride and selenourea in the 1:1 ratio.
Volume 43, 2020
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode