• M MOHAMED ISMAIL

Articles written in Bulletin of Materials Science

• Optimization of RF sputtering process parameters on electrical resistivity, deposition rate and sensitivity of Al-doped ZnO thin films grown on Si substrate using grey-Taguchi technique

Increasing environmental pollution globally demands gas sensors for monitoring urban air quality, fire and exhaust from automobiles. The need for high performance gas sensors requires a good control over sensing material structure. This paper studies the suitability of Al-doped ZnO thin films for development of CO gas sensors. Deposition of Al-doped ZnO thin films on Si substrates by the radio frequency sputtering technique was carried out to study the influence of process parameters. The process parameters selected for the analysis were power, deposition time, substrate temperature and working pressure. An orthogonal array L16 (4$^4$), signal-to-noise ratio and analysis of variance (ANOVA) were performed to optimize the electrical resistivity, deposition rate and sensitivity of the thin films using the Taguchi method. Grey relational grade (GRG) was performed to obtain multiple-performance characteristics of the thin films by optimizing the process parameters. GRG analyses identified the process parameters: power 150 W, deposition time 35 min, substrate temperature 25$^{\circ}$C and working pressure 1.5 Pa showed optimal multiple-performance characteristics. ANOVA analyses indicate that power and substrate temperature show significant effect compared with other parameters. Thin films at the annealingtemperature (450$^{\circ}$C) showed a decrease in electrical resistivity and an increase in sensitivity. At the sensor operatingtemperature of 150$^{\circ}$C, Al-doped thin films exhibited the lowest resistivity $3.76 \times 10^{−3}$ $\Omega$-cm and the highest sensitivity of 59%. The optimal multiple-performance characteristic of thin film sample identified is found suitable for CO gas-sensing applications.

• # Bulletin of Materials Science

Volume 44, 2021
All articles
Continuous Article Publishing mode

• # Dr Shanti Swarup Bhatnagar for Science and Technology

Posted on October 12, 2020

Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020