H S Jayanna
Articles written in Bulletin of Materials Science
Volume 17 Issue 6 November 1994 pp 1091-1094
Thermal expansion of irradiated nylon-6 from 10 K to 340 K
Thermal expansion of irradiated nylon-6 has been studied in the temperature range 10 to 340 K using a three-terminal capacitance bridge technique. Irradiation is carried out using cobalt-60 γ-rays up to 500 Mrad dosage. Radiation enhances chain scission over crosslinking. α increases from 0 to 250 Mrad between 10 to 340 K and not much variation is observed between 250 to 500 Mrad for samples from 10 to 250 K.
Volume 18 Issue 8 December 1995 pp 1007-1011
Thermal conductivity measurements at low temperatures
P Balaya H S Jayanna Hemant Joshi G Sumana V G Narasimha Murthy V Prasad S V Subramanyam
We describe briefly the experimental facilities developed for the measurement of thermal conductivity of solids in the temperature range 10K–300K. Different techniques have been used for the determination of thermal conductivity, depending on the relaxation time of the system under investigation. Measurements on stainless steel 304, using steady state and non-steady state methods are presented. Values of thermal conductivity obtained by both these methods agree to each other and are consistent with those reported earlier.
Volume 46, 2023
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode