H B Muralidhara
Articles written in Bulletin of Materials Science
Volume 29 Issue 5 October 2006 pp 497-503 Corrosion Studies
Zinc electrodeposition from sulphate bath was carried out in presence of condensation product formed between glycyl–glycine (GGL) and furfural (FFL). The bath constituents were optimized through Hull cell experiments. Operating parameters such as pH, temperature and current density were also optimized. Current efficiency and throwing power were measured. Polarization study revealed shift of potential towards negative direction in the presence of addition agents. Corrosion resistance test revealed good protection of base metal by zinc coating obtained from developed electrolyte. SEM photomicrographs showed fine-grained deposit in the presence of condensation product. IR spectrum of the deposit showed inclusion of condensation product in the deposit during plating. The consumption of brightener in the lab scale was 7 mLL-1 for 1000 amp-h.
Volume 31 Issue 4 August 2008 pp 585-591 Nanomaterials
Nano zinc coatings were deposited on mild steel by electrodeposition. The effect of additive on the morphology of crystal size on zinc deposit surface and corrosion properties were investigated. Corrosion tests were performed for dull zinc deposits and bright zinc deposits in aqueous NaCl solution (3.5 wt.%) using electrochemical measurements. The results showed that addition of additive in the deposition process of zinc significantly increased the corrosion resistance. The surface morphology of the zinc deposits was studied by scanning electron microscopy (SEM). The preferred orientation and average size of the zinc electrodeposited particles were obtained by X-ray diffraction analysis. The particles size was also characterized by TEM analysis.
Volume 38 Issue 1 February 2015 pp 271-282
Hierarchical mesoporous NiO nanoflakes (NiOs) have been synthesized in high yield via a simple, economical and environmentally friendly hydrothermal route. The as-prepared NiOs were characterized by powder X-ray diffraction (PXRD), scanning electronicmicroscopy (SEM), transmission electronmicroscopy (TEM), selected area electron diffraction patterns (SAED), X-ray energy dispersive spectroscopy (EDS) and nitrogen adsorption–desorption techniques (Brunauer–Emmett–Teller, BET). Adsorption of heavy metal ions onto the as-prepared sample from aqueous solutions was investigated using differential pulse anodic stripping voltametry (DPASV) technique and discussed. The product possesses a BET surface area of 69.27 m2 g-1. It is found that NiOs exhibited the excellent performance for the removal of Hg(II), Pb(II) and Cd(II) from aqueous solution. The equilibrium adsorption data of Hg(II), Pb(II) and Cd(II) on the as-prepared NiOs were analyzed by Langmuir and Freundlich models, suggesting that the Langmuir model provides the better correlation of the experimental data. The adsorption capacities for removal of Hg(II), Pb(II) and Cd(II) were determined using the Langmuir equation and found to be 1324.5, 1428.9 and 1428.5 mg g-1, respectively. Adsorption kinetics of all the metal ions followed pseudo second-order model. Moreover, NiOs can be recycled by simple acid treatment, which could retain the high removal efficiency in three successive cycles. This study suggests that nanoflakes could be explored as a new adsorbent with high efficiency and recyclability for removing heavy metal ions from aqueous solution.
Volume 44, 2021
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode