Articles written in Bulletin of Materials Science
Volume 25 Issue 3 June 2002 pp 213-217 Alloys and Steels
Under the condition of tungsten inert gas shielded welding (TIG) + shielded metal arc welding (SMAW) technology, the microstructure in the welding zone of 9Cr–1Mo–V–Nb (P91) heat-resisting steel is studied by means of X-ray diffractometry (XRD) and transmission electron microscopy (TEM). The test results indicate that when the weld heat input (𝐸) of TIG is 8.5 ∼ 11.7 kJ/cm and the weld heat input of SMAW is 13.3 ∼ 21.0 kJ/cm, the microstructure in the weld metal is composed of austenite and a little amount of 𝛿 ferrite. The substructure of austenite is crypto–crystal martensite, which included angle. There are some spot precipitates in the martensite base. TEM analysis indicates that the fine structure in the heat-affected zone is lath martensite. There are some carbides (lattice constant, 1.064 nm) at the boundary of grain as well as inside the grain, most of which are Cr23C6 and a little amount of (Fe, Me)23C6.
Volume 34 Issue 7 December 2011 pp 1371-1374
NaEuF4 spindle-like nanocrystals have been synthesized through a simple hydrothermal method. The nanocrystals were well crystallized and exhibited fine morphology, as indicated by X-ray diffraction, transmission electron microscope and selected area electron diffractometer. The luminescence properties of these NaEuF4 products were investigated.
Volume 46, 2023
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode