1. Home
    2. Journals
    3. Bulletin of Materials Science

    • Ehab A El-Danaf

      Articles written in Bulletin of Materials Science

    • Volume 34 Issue 7 December 2011 pp 1447-1453

      Low temperature enhanced ductility of friction stir processed 5083 aluminum alloy

      Ehab A El-Danaf Magdy M El-Rayes Mahmoud S Soliman

      More Details Abstract Fulltext PDF

      Commercial 5083 Al rolled plates were subjected to friction stir processing (FSP) with two different processing parameters, having 430 and 850 rpm tool rotational speed with a single traverse feed rate of 90 mm/min. These FSP conditions resulted in two fine grained microstructures of 0.95 𝜇m (430 rpm) and 2.6 𝜇m (850 rpm). Tensile elongations were measured at a relatively low temperature of 250°C at three strain rates, and demonstrated that a decrease in grain size resulted in significantly enhanced ductility and lower forming loads. The occurrence of a relatively high value of strain rate sensitivity, 𝑚 of 0.45 for a grain size of 0.95 𝜇m, suggests the operation of superplastic deformation under these present experimental conditions.

  • Bulletin of Materials Science | News

    • Dr Shanti Swarup Bhatnagar for Science and Technology

      Posted on October 12, 2020

      Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
      Chemical Sciences 2020

      Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
      Physical Sciences 2020

    • Editorial Note on Continuous Article Publication

      Posted on July 25, 2019

      Click here for Editorial Note on CAP Mode

© 2022-2023 Indian Academy of Sciences, Bengaluru.

Contact | Site index