B K Singh
Articles written in Bulletin of Materials Science
Volume 30 Issue 3 June 2007 pp 235-238 Clay Materials
Instrumental characterizations of the clay were performed by different techniques such as XRF, XRD and FTIR. XRF shows the chemical compositions of the clay where Al-oxide and silica oxide are present in major quantity whereas XRD confirms the presence of these minerals in clay. FTIR studies show the presence of quartz, alumina, haematite and different mineral matters.
Volume 33 Issue 2 April 2010 pp 179-183 Alloys
The effect of H+ ion implantation on surface morphology of the titanium alloy, Ti–6Al–4V, was studied, following H+ ion implantation of 150 keV and 250 keV energy to fluence of 2.6 × 1018 cm-2 and 2.5 × 1019 cm-2, respectively at ambient temperature. No detectable change was observed in surface features of either of the above specimen immediately after the implantation. However, vein like features (VLF) were observed to appear on the surface of the sample, implanted at 150 keV to a fluence of 2.6 × 1018 cm-2, following natural ageing at room temperature for 150 days. Subsequent annealing of the above naturally aged sample, at 423 K for 150 min under vacuum (10-3 torr), led to development of a macroblister.
In sharp contrast in the other sample, implanted by H+ ions of higher energy (250 keV) to higher fluence of 2.5 × 1019 cm-2, neither there was any effect of natural ageing following the implantation nor that of subsequent annealing at 423 K and ageing on its surface morphology.
Volume 44, 2021
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode