• A S ROUHAGHDAM

      Articles written in Bulletin of Materials Science

    • Study on wear and corrosion properties of functionally graded nickel–cobalt–(Al$_2$O$_3$) coatings produced by pulse electrodeposition

      A KARIMZADEH M ALIOFKHAZRAEI A S ROUHAGHDAM

      More Details Abstract Fulltext PDF

      Functionally graded nickel–cobalt coatings with/without alumina nanoparticles were pulse electrodeposited on a carbon steel substrate by a continuous decrease in duty cycle from 95 to 10% at different frequencies of 100, 500and 1000 Hz. The effect of pulse parameters on the nanoparticle content, chemical composition, microstructure, corrosion properties and tribological behaviour of coatings was studied. Energy-dispersive X-ray spectroscopy analysis showed that the amount of cobalt is gradually reduced and the content of alumina nanoparticles is increased from the substrate/coating interface to the surface. Based on the electrochemical studies in 3.5 wt% NaCl, the nanocomposite coatings gain the highest corrosion resistance at the lowest frequency. Also, the hardness of coatings gradually increased. Evaluation of the tribological behaviour of coatings by a pin-on-disk wear test showed that the nanoparticles have a positive effect on wear resistance and improve it by increasing frequency.

  • Bulletin of Materials Science | News

    • Dr Shanti Swarup Bhatnagar for Science and Technology

      Posted on October 12, 2020

      Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
      Chemical Sciences 2020

      Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
      Physical Sciences 2020

    • Editorial Note on Continuous Article Publication

      Posted on July 25, 2019

      Click here for Editorial Note on CAP Mode

© 2017-2019 Indian Academy of Sciences, Bengaluru.