• Fulltext


        Click here to view fulltext PDF

      Permanent link:

    • Keywords


      PLZT thin films; pure perovskite phase; RF sputtering; lift-off process; micro-cantilevers.

    • Abstract


      In the present work, we report the preparation of PLZT thin films in pure perovskite phase by RF magnetron sputtering without external substrate heating and their integration with micro-cantilevers. The ‘lift-off’ process for patterning different layers of a micro-cantilever including PLZT, Pt/Ti and Au/Cr was employed. The basic requirement of lift-off process is that the deposition temperature should not exceed 200°C otherwise photoresist will burn out. Therefore, one of the aims of the present work was to prepare PLZT film at lower deposition temperatures, which can be subsequently annealed to form pure perovskite phase. This also strongly favours the incorporation of ‘lift-off’ process for patterning in the complete process flow. As no external substrate heating was required in the deposition of PLZT film, this objective has been successfully accomplished in the present work. The ‘lift-off’ process has been successfully adopted for patterning the composite layers of PLZT/Pt/Ti and Au/Cr using thick positive photo-resist (STR-1045). Different types of cantilever beams incorporating PLZT films have been successfully fabricated using ‘lift-off’ process and bulk micromachining technology. The proposed process can be advantageously applied for the fabrication of various MEMS devices.

    • Author Affiliations


      Ravindra Singh1 T C Goel2 Sudhir Chandra1

      1. Centre for Applied Research in Electronics, Indian Institute of Technology Delhi, New Delhi 110 016
      2. BITS Pilani Goa Campus, Zuari Nagar, Goa 403 726
    • Dates

  • Sadhana | News

    • Editorial Note on Continuous Article Publication

      Posted on July 25, 2019

      Click here for Editorial Note on CAP Mode

© 2023-2024 Indian Academy of Sciences, Bengaluru.