In this work, the development of a robust method for the fabrication of a low-cost transparent conducting electrode (TCE) via the addition of graphene in the spray-pyrolysis of fluorine-doped tin oxide (FTO) is explained. Alcoholic suspensions of few-layer-graphene were produced via the liquid exfoliation of graphite in different alcoholic solutions as sonicating solvent. These mixtures were then mixed with ammonium fluoride and tin (II) chloride dihydrate precursors to fabricate graphene/FTO composite through spray pyrolysis. Graphene exfoliated with 50% aqueous ethanol proved to yield improved TCE properties with nearly two-fold enhancement in figure of merit (FOM) measured in terms of the ratio of optical transmittance and sheet resistance. Using optimized spraying conditions, graphene/FTO coatings still yielded slightly higher FOM compared to plain FTO. The increase in FOM is largely attributed to the decrease in sheet resistance with the incorporation of graphene flakes.
Volume 44, 2021
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode