• Fulltext

       

        Click here to view fulltext PDF


      Permanent link:
      https://www.ias.ac.in/article/fulltext/boms/034/04/0815-0823

    • Keywords

       

      Friction welding; welding parameters; microstructure.

    • Abstract

       

      In this study, different welding parameters were applied to two different steels with high alloys and mechanical and metallographical investigations are performed. Thus, the optimum welding parameters were determined for these materials and working conditions. 12.30 diameter steel bars made up of 1.4871 (X53CrMnNiN219) and 1.4718 (X45CrSi93) steel were used as experimental material. The material loss increased with increase in friction and rotating pressure. No fracture at the welding region was observed and the highest fracture energy was identified in B5 group. Based on micro hardness investigation; the hardness profile reached its minimum value at the welding region.

    • Author Affiliations

       

      Mehmet Uzkut1 Bekir Sadik Ünlü1 Mustafa Akdağ2

      1. Department of Machinery, Vocational High School, Celal Bayar University, 45400, Turgutlu, Manisa, Turkey
      2. Department of Mechanical Engineering, Faculty of Engineering, Celal Bayar Üniversity, 45140, Muradiye, Manisa, Turkey
    • Dates

       
  • Bulletin of Materials Science | News

    • Editorial Note on Continuous Article Publication

      Posted on July 25, 2019

      Click here for Editorial Note on CAP Mode

© 2017-2019 Indian Academy of Sciences, Bengaluru.