Effect of a new condensation product on electrodeposition of zinc from a non-cyanide bath
Ganesha Achary H P Sachin Y Arthoba Naik T V Venkatesha
Click here to view fulltext PDF
Permanent link:
https://www.ias.ac.in/article/fulltext/boms/030/03/0219-0224
Zinc electrodeposition from sulphate chloride bath was carried out in presence of condensation product formed between chitosan and veratraldehyde. The bath constituents and operating parameters such as pH, temperature and current density were optimized through Hull cell experiments. Current efficiency and throwing power were measured. Polarization study revealed high shift of potential towards negative direction in the presence of addition agents. Corrosion resistance test revealed good protection of base metal by zinc coating obtained from developed electrolyte. SEM photomicrographs showed fine-grained deposit in the presence of condensation product. The IR spectrum of the deposit showed inclusion of the condensation product during electroplating. The consumption of brightener in the lab scale was 5 mLL-1 for 1000 amp-h.
Ganesha Achary1 H P Sachin1 Y Arthoba Naik1 T V Venkatesha1
Volume 46, 2023
All articles
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode
© 2022-2023 Indian Academy of Sciences, Bengaluru.