Microstructure at the diffusion bonding interface between Fe3Al and steel including Q235 low carbon steel and Cr18–Ni8 stainless steel was analysed and compared by means of scanning electron microscopy and transmission electron microscopy. The effect of Cr and Ni on microstructure at the Fe3Al/steel diffusion bonding interface was discussed. The experimental results indicate that it is favourable for the diffusion of Cr and Ni at the interface to accelerate combination of Fe3Al and steel during bonding. Therefore, the width of Fe3Al/Cr18–Ni8 interface transition zone is more than that of Fe3Al/Q235. And Fe3Al dislocation couples with different distances, even dislocation net occurs at the Fe3Al/Cr18–Ni8 interface because of the dispersive distribution of Cr and Ni in Fe3Al phase.
Volume 43, 2020
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode