The sliding wear of isotactic polypropylene (PP), polyethylene terephthalate (PET) and their blends was evaluated as a function of applied pressure and composition against a stainless steel counter face in dry condition. Wear rate decreases with the addition of PET in the blend. The wear was observed in two stages, the moderate wear and high wear while increasing the applied pressure on test samples. The addition of PET in PP helps in increasing the limit of moderate wear towards the high-pressure side. Microstructure and worn surfaces of samples were observed by scanning electron microscope. The wear phenomenon has been discussed based on wear losses and worn surfaces.
Volume 46, 2023
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode