Click here to view fulltext PDF
Permanent link:
https://www.ias.ac.in/article/fulltext/boms/025/06/0513-0515
Zinc oxide (ZnO) is a versatile material for different commercial applications such as transparent electrodes, piezoelectric devices, varistors, SAW devices etc because of its high piezoelectric coupling, greater stability of its hexagonal phase and its pyroelectric property. In fact, ZnO is a potential material for gas sensor applications. Good quality ZnO films were deposited on glass and quartz substrates by a novel CVD technique using zinc acetate as the starting solution. X-ray diffraction confirmed the crystallinity of the zinc oxide film and SEM study revealed uniform deposition of fine grains. Undoped ZnO films were used for detection of dimethylamine (DMA) and H2 at different temperatures by recording the change in resistivity of the film in presence of the test gases. The response was faster and the sensitivity was higher compared to the earlier reported ZnO based sensors developed in our laboratory. The main objective of this work was to study the selectivity of the ZnO film for a particular gas in presence of the others. The operating temperature was found to play a key role in the selectivity of such sensors.
Volume 46, 2023
All articles
Continuous Article Publishing mode
Prof. Subi Jacob George — Jawaharlal Nehru Centre for Advanced Scientific Research, Jakkur, Bengaluru
Chemical Sciences 2020
Prof. Surajit Dhara — School of Physics, University of Hyderabad, Hyderabad
Physical Sciences 2020
Click here for Editorial Note on CAP Mode
© 2022-2023 Indian Academy of Sciences, Bengaluru.